Enzo Biochem alpha-Galactosylceramide

At-a-glance

CAS Number

158021-47-7

Chemical Formula

C₅₀H₉₉NO₉

Molecular Weight

858.3

Purity

≥98% (TLC)

Source

Synthetic.

Appearance

White solid.

Solubility

KRN7000 is inherently an extremely hydrophobic molecule, therefore, almost all the methods for solubilizing this material in primarily aqueous media will contain at least some detergent. For cell culture or other in vivo models, it is recommended that the KRN7000 be initially dissolved in a 2:1 mixture of chloroform and methanol. This solution should then be aliquoted into amounts suitable for a day’s use into glass vials. After aliquoting, the chloroform/methanol solvent can be evaporated off under a stream of nitrogen or argon. We recommend turning the tube during this process to try to get the KRN7000 deposited in as thin a film as possible. The thinner the KRN7000 layer is, the easier it will be to reconstitute it. These dry aliquots can then be stored under nitrogen or argon at -20°C for several months or until needed.On the day of the experiment, use a dried aliquot and reconstitute it using any of the options listed below: PBS with 0.5% Tween-20. Note: It will be necessary to warm at 37°C and sonicate for 2 hours or more in a water bath sonicator in order to get the material to dissolve. Heating and sonication should be done immediately prior to every use. 5.6% sucrose with 0.75% L-histidine and 0.5% Tween-20. Heating to 80°C for several minutes will be necessary with this solvent system. 100% DMSO (anhydrous). It is critical that the DMSO be completely anhydrous. Heating to 80°C may be necessary to get the KRN7000 to completely dissolve. Please note: while this method will produce a true clear solution in DMSO, the KRN7000 will be very likely to precipitate out as soon as the DMSO is diluted into aqueous media. It is recommended that the aqueous media the DMSO stock solution will be diluted in should contain 10% serum, or BSA and that the DMSO stock solution be diluted no more than 1/100. Depending upon the make-up of the aqueous buffer, there may well still be a precipitate, however the precipitate should eventually disappear with warming and repeated vortexing or sonication in a water bath sonicator. This may take some time and will likely need to be repeated each time an aliquot is thawed for use.Depending upon the solvent system used and the final concentration of the KRN7000, the results may be either a true clear solution or a somewhat cloudy suspension. The cloudy suspensions are not a problem, and will work fine when treating cells, just make sure they are mixed well immediately before use.

Storage Condition

Long-term: -20°C; Shipping: Blue Ice

Condition

Surplus/second-hand; stored under manufacturer-recommended conditions.